罗次风机（ROM. Primary fan）.docVIP

罗次风机（ROM. Primary fan） Introduction to the English: Roots blower type: straight and linked The principle of The roots blower is a volume rotary blower, which USES two leaf-shaped rotor to make relative motion in the cylinder to compress and transport the gas rotary compressor. This compressor engages the two rotors with the synchronous gear on the rotor shaft. Rotor portion of every sunken into the surface of working volume and the cylinder wall, in the process of the rotor turning away from inspiratory mouth gas, when moved to vent and vent near instantaneous, connected with high pressure gas flow, the pressure in the working volume suddenly rise, and then transported to the gas exhaust passage. The two rotors alternate in turn. The two rotors are not in contact with each other, and they are sealed by tight control clearance, so the gas discharged is not polluted by oil. structure Due to the compression of air flow velocity and pressure due to periodic adsorption, exhaust and instantaneous compression, a larger aerodynamic noise can be generated. In addition, the gap between the rotor and the rotor and the cylinder can cause gas leakage, thus reducing the efficiency. The exhaust volume of the roots blower is 0.15 ~ 150 meters (/ min, 150 ~ 3000 RPM). The single-stage pressure ratio is usually less than 1.7 and can reach up to 2.1, which can be used in tandem. Features and others Characteristics: the maximum characteristic is that when the pressure is adjusted in the allowable range, the flow rate is very small, and the pressure selection is wide and has the characteristics of forced gas transmission. The medium does not contain oil when conveying. Simple structure, convenient maintenance, long service life and small vibration of the whole machine. Medium: roots blower transport medium for clean air, clean and kerosene, sulfur dioxide and other inert gas, given with the above characteristics, and thus can be widely used to metallurgy, chemical industry, fertilizer