维修方式（Maintenance mode）.docVIP

维修方式（Maintenance mode） This article is contributed by China Care/Go To Market mobile phone maintenance HMX in August 2009 one The main content ? 1. Voltage? 2. Current method? Resistance? 5. Observation? 6. Temperature? 7. Cleaning? 8. Remedial welding? 9. Reload software? 10. Shake off? 12. Cross-connection? 13. Self-inspection? 11. False load method? 4. Signal tracking method ? Special statement ? The Nokia 2009 1. Voltage method This is one of the most basic methods used in all home appliances maintenance. The maintenance personnel should pay attention to the accumulation of some key voltage data in different states. These states are: call status, single receiving state, single launch status, waiting state. Key point of the voltage data are: power management IC of each output voltage and the control voltage, RFVCO working voltage, 38.4 MHz VCO working voltage, the control voltage and working voltage, CPU, RF IC working voltage, baseband reset voltage IC working voltage, LNA working voltage, dc bias voltage I/Q road and so on. In most cases, the method can exclude the failure of the machine to work and a launch to protect the shutdown. ? Measuring voltages are generally used with a universal meter, a digital multimeter or oscilloscope. ? NOKIA mobile phone power points several situation, baseband mainly such as VCORE voltage, VIO, VANA, VAUX is constant dc voltage, can be detected in standby state, not forcibly hold down the power button can also be measured when the phone is switched on. Other parts of the circuit voltage depends on the specific circumstances job to energy to start the corresponding circuit, to such voltage with a multimeter can be difficult to detect, even to just an average, especially the working voltage of rf VCO and the control voltage, LNA work of electricity, is rapidly changing the pulse signal, in the conditional case, the suggestion is measured with the oscilloscope. ? Note the good grounding of the multimeter or oscilloscope