EQ混音（EQ mix）.docVIP

EQ混音（EQ mix） The human voice deals with the golden rule of EQ 1. if the sound is cloudy, please attenuate the band near 250hz. 2. if the sound sounds like a horn, please attenuate the band near 500Hz 3., when you try to make the sound sound better, consider using attenuation 4. when you try to make the sounds different, consider raising them 5. dont amplify the sound you didnt have Here is a table that reflects some auditory associations caused by some octave points. 31hz the rumble of thunder rumbling in the distance. I feel a dull pain in my chest. 65Hz has depth, the so-called deep dive 125Hz boomed, and his heart pounded. Warmth. 250Hz plump or cloudy 500Hz car horn 1kHz whack (percussion sound?! Thats a bad translation 2KHz that sounds of things, on the ga la. 4kHz edge, sharp sense 8kHz high-frequency Whistler or dental, the outline is clear, ouch! 16KHz air sense The function of some common frequency points 50Hz, this is our lowest frequency band, the most important frequency band you can hear outside the hall, and also the frequency of dancing. By properly lifting it, you will get an uplifting drum sound. But be sure to cut off all the 50Hz sounds in the vocals, because that must be the voice of wheat. 70 to 100Hz, which is the necessary frequency for our vigorous and vigorous BASS, and also the frequency of vocal resection. Remember, the BASS and the ground drum dont raise the same frequency, otherwise the drum will be hidden. 200 ~ 400Hz, the band has several main purposes are as follows, first is the snare wood sense sound audio segment; secondly, it is to eliminate the voice band dirty feeling; third, to promote the band will be the guitar, the sound becomes warm; fourth, the cymbals and PERCUSSION, the attenuation band can increase their crisp sense. Of these, at the 250Hz frequency point, a proper gain to the ground drum can make the drum sound less heavy, which is used in a lot of clear pop music. 400 to 800Hz, to adjust this frequency band, you can g