田湾 U1C9 紧急换料方案研究设计及流程优化.pdfVIP

CORPHY‐2014——第15 届反应堆数值计算与粒子输运学术会议暨2014 年反应堆物理会议  四川成都，2014 年8 月25 日至27 日  田湾U1C9 紧急换料方案研究设计及流程优化 1 1 1 1 1 1 2 王红霞 徐敏 程和平 霍小东 易璇 于洋 李友谊 （1 中国核电工程有限公司，北京，100840 2 中国核电江苏核电有限公司，江苏 连云港222042 ） 摘要：田湾核电站1 号机组第8 循环寿期初，堆芯运行监测参数分析时发现疑似有 1 组燃料组件发生破损。此时第 9 循环的换料设计工作还未正式开展，因此根据可能的紧急换料，不能按照以往的换料程序进行正常换料流程。第9 循环换料时，还需要考虑第 8 循环寿期末落棒试验可能发生控制棒卡滞的情况，这给换料设计增加了相当的难度。 本文针对这种有多种问题并存的情况开展方案研究设计及换料流程优化，建立了一套紧急换料方案设计的分析方法， 提供了方案设计的一种思路，对压水堆核电站的紧急换料具有参考意义。 关键词：换料方案设计；流程优化；紧急换料 TianWan U1C9 Emergency Refueling Loading Research Design and Process Optimization 1 1 1 1 1 1 2 WANG Hongxia , XU Min , CHENG Heping , HUO Xiaodong , YI Xuan , YU Yang , LI Youyi (1.China Nuclear Power Engineering Co, Beijing, 100840; 2.Jiangsu Nuclear Power Corporation, Lianyungang, 222042) Abstract: According to core operation measurement parameters, it is found that there is a damaged fuel assembly in core at the beginning of Cycle 8 of TNPS Unit 1. The design work of fuel reloading is not started yet. Because of the possibility of emergency refueling, the normal refueling process would not be actualized. During the refueling of Cycle 9, the situation where the control rods may be stuck should be considered, which increases the difficulty of fuel loading design. Aiming at solving these problems we make the fuel loading pattern design research and the refueling design process optimization, establish a series of analysis methods for emergency refueling program designed, providing a conceptual design idea for PWR nuclear power plant emergency refueling with a reference value. Key words: fuel loading design ； process optimization ；emergency refueling 1