显像管切颈（The tube cuts the neck）.docVIP

显像管切颈（The tube cuts the neck） The cause of the neck cutting and the key point of overhaul Cut the root cause of the neck is abnormal field output circuit, dc voltage (V) directly to be present on the deflection, horizontal bright line forced migration to the neck, like focus sunlight will fuse tube neck, generally use 7830 old machines, such as AN5521, theres a output capacitance characteristic is without exception are, when the electrolytic capacitor completely breakdown, dc voltages on the deflection coil head, cut the neck is inevitable. Solution of capacitance of common problem is loss of capacity, beat the leakage, leakage rust - rare completely broken foot breakdown (just output capacitance breakdown naturally less), and because of that, havent seen cut neck. The basic working principle of deflection is that under the action of pulse voltage, the scanning line (deflection) is constantly moving up and down to form a grating. When you stop working on the spot, all you can see is the horizontal line. When a fixed direct current is added to the field, the horizontal line is shifted to a certain position (the zero potential is in the middle). Stop on the screen and burn the phosphor, while on the thin tube neck, the result can be imagined. Is, in fact, we can see the hazy grating corner or ejection of type electronic light, sometimes visible rainbow, the new models of especially big screen now, has been widely used dual power supply (+ 12 v) field output integrated circuit - dont ask why? Ill tell you! When the + - voltage balance is added, you should know that the midpoint voltage is zero. This one is the same as the one were familiar with. In the power machine, the mid-point voltage is not at zero. The power is not enough to burn the deflected coil, But what is more frightening is the possibility of scrapping the picture tube. The reason for the neutral voltage is not zero. It may be a rectifier diode breakdown, open circuit, or a block power supply foot solderin