375现场校验阀门（On-site check valve）.docVIP

375现场校验阀门（On-site check valve） DVC6010 digital valve positioner is a new generation of process control product designed by EMERSON company for the direct stroke control valve actuator. The utility model has the advantages of convenient adjustment, easy maintenance, high safety factor, self diagnosis, etc., and is well liked by a large number of users, and the adjusting valve on the production device of our company is also assembled with the positioner. In order for more instrument maintenance personnel to use it, the verification methods are summarized as follows. Connection of field communicator and HART loop of type 375 Type 375 field communication devices (referred to as 375) can communicate with any HART compatible devices in the control room, instrument field or loop, and the DVC6010 digital valve positioner is a HART compatible device. The 375 and the proper connector are connected in parallel with the instrument or load impedance, and the HART connection is insensitive to polarity. To ensure that the 375 can work properly, at least the 4mA current and the 12VDC voltage are supplied to the DVC6010, and the impedance in the circuit shall not be less than 250 ohms. 375 there are 3 ports at the top. 2 of them are red and 1 are black. The red port is the positive of each protocol, and the black port is the common end of the 2 protocols. The cap device ensures that only 1 pairs of ports are exposed at any time. The port flag indicates which port corresponds to which protocol. Two. Start type 375 field communicator Press hold / key until the multi-function LED indicator blinks, indicating that the device is powered up (about 2 s). For an open / critical position, see figure 1. During launch, 375 will automatically install all upgrade software on the system card. When finished, the main menu of 375 will be displayed: (1) HART Application (start HART application) (2) FOUNDATION FieldbusApplication (startup Foundation Fieldbus application) (3) Setting (configuration /