东芝166维修代码（Toshiba 166 maintenance code）.docVIP

东芝166维修代码（Toshiba 166 maintenance code） Documents from the network, I collected, finishing, and if there are omissions, errors, but also please correct me! Toshiba 166 maintenance code How to use the department management function of Toshiba 163/166 copiers In the function setting mode 1+ *, you can turn on and off certain functions by modifying the 0 and 1 attributes of each bit on the 8 bit binary I. code description 1, function type code: 100- function, 101- computer function, 102-HOME 2, 100, 18 of which only 2 byte code set as part of the code management (0 do not enable the department code 1, code 18 enabled); the default setting isbyte value: 010010003, operating instructions 1 + * boot into the function setting mode, input function type code by pressing Start key input function code press Start when the screen shows a 8 bit binary code start screen display Sixth The seventh bit code presses the 200% button to switch to 5 Four The 3 bit code again presses the 200% button to display 2 One 0 bit code Two, set the department code 1, 1 + * boot, enter 100 Enter 18 Then select the second bit byte and change it to 1 to enable the department code 2, set the process of department code 8 + Start boot sector code mode enter the new three digit code Department press Start button to confirm the LED screen previously entered three department code will not stop flashing then press the Start button that will save the department code to RAM otherwise, press the Clear button, do not save Shutdown Note: the department code must be a three bit numeric code from 001 to 999. If you press the Start key, the department code entered already exists, with a sound prompt on the side, and the screen will return to its original state Three, delete the department code process 8 + Start boot into the department code input mode to delete the three digit code department or press INTERRUPT button to automatically search press FUNCTION CLEAR button to confirm the LED screen will flas