HJM横截面流量计（HJM cross sectional flow meter）.docVIP

HJM横截面流量计（HJM cross sectional flow meter） HJM type cross-section flowmeter (pioneered in China and awarded national patent) contact: Beijing huaneng meter ma:No straight pipe is needed The actual measurement accuracy is the highest I. working principle The flow distribution in the pipeline is one with sufficient straight pipe If the flow rate in the pipe is stable and definite, the flow velocity in the pipe is stable In the form of cutting, the velocity distribution in the pipeline is that the self-tube wall is equal to zero Continuous change to the maximum flow rate of the piping center. So its in the middle You can always find a point in the process, and you can measure it at this point The velocity of the velocity is the average velocity. This is in the actual work scene, is very Difficult to do, especially the second wind, extremely irregular. Because there is no Sufficient straight pipe section, the flow rate of each point in the cross section of the pipe is not Again, its hard to find a point that represents the average velocity. In this In this case, if you use the device for measuring point speed ( S-type pit-trust), The linear velocity of a straight line (that is, the average speed tube of various types) can calculate the average speed of the cross section, and there is no accurate accuracy. Because the velocity in the pipeline is not constant, the pipe section can be divided into many small unit area Ai. Lets say each of these units The velocity in the product is zero Vi, the total flow is equal to the sum of the traffic flows over a number of small unit areas, namely: (n). The party Q = Σ AiVi I = 1, Its called the velocity area method. The international organization for standardization has confirmed this approach and has established appropriate measurement specifications. Unit area The greater the division, the more accurate the measured flow. Cross-sectional flowmeter is designed based on this principle and is practical The application is c