usb接线法（The usb connection）.docVIP

usb接线法（The usb connection） This year on the market of the motherboard, the USB interface board, use a nine standard USB interface, the nine is empty, relatively easy to determine. But most of the brands are using customized computer motherboard manufacturers, we did not use the maintenance instructions; and like the previous 815 motherboard, 440BX, 440VX motherboard, pre USB connection is very chaotic, there is not a unified standard. When we repair this kind of machine, how do we judge its connection? Note: the line color of the standard chassis front USB interface and the meaning of the corresponding pin are: 1 Black / ground, 2 green /+DATA, 3 white /-DATA, and 4 red /+5V. That is to say, in the USB interface pin of the main board, the tag 1 must plug in the front USB interface, the black connection, and the mark 2 must plug in the green wiring of the front USB interface, and so on. If accidentally connected, it will lead to the failure of the interface circuit, the light will lead to the host power failure, and then burned circuit devices, carefully check the wiring, the correct connection can be. One, now, I put on the market more common motherboard pre USB access method for summary, for your reference. (Note: - Representative Representative - pin, needle position but no pin. ) 1, six needle double row This interface is not commonly used, the USB pin arrangement of this type in elite P6STPFL (REV:1.1) for Haier motherboard, small Superman 766 host. The power supply is negative and the power supply is shared by two pre USB interfaces, so the two USB interfaces in front need 6 wires to connect with the main board, and the wiring is shown as follows. - DATA1+ - DATA1- - VCC - DATA2- - DATA2+ - GND 2, eight needle double row This interface is the most common, actually takes ten needle position, but there are two needle position is empty, such as the elite P4VXMS (REV:1.0) motherboard. The board also provides a standard nine connection, this is to facilitate easy co