基于SG3525控制的车载逆变电源设计.PDF

第41卷第1期 中国测试 Vol.41 No.1 2015年 1月 CHINA MEASUREMENT TEST January，2015 doi院10.11857/j.issn.1674-5124.2015.01.020 基于SG3525控制的车载逆变电源设计 付 瑶袁 谭智力袁 于 珊 （中国地质大学（武汉）机械与电子信息学院，湖北 武汉 430074） ：第 摘 要院介绍一种基于SG3525控制的车载逆变电源的工作原理和电路设计。主电路采用典型两级变换的逆变结构 1 （ ；第 级变换通过SG3525控制器产生高频脉冲宽带调制 PWM）波，对输入信号升压整流 2级变换通过NE556和CD4013 芯片搭建逆变控制电路，将直流信号变换成工频信号；设计电池过压、欠压，输出过流、过热和输出欠压等保护电路。经 验证该逆变电源具有可靠性高、电路简单、体积小等优点。 ； ； ； 关键词院SG3525控制 两级变换 脉冲宽带调制 保护电路 文献标志码院A 文章编号院1674-5124渊2015冤01-0077-04 Design of vehicle inverter power supply based on SG3525 control FU Yao，TAN Zhili，YU Shan （College of Mechanical and Electronic Information，China University of Geosciences， Wuhan 430074，China） Abstract: Working principle and circuit design of vehicle inverter power supply based on SG3525 control were introduced. The main circuit adopted typical two-stage inverter structure transformation. The first-stage transformation produced high frequency PWM wave using SG3525 controller to invert and rectify the input signal. The second-stage transformation transformd the DC signal into a frequency signal through inverter control circuit which was built using NE556 and CD4013. In addition，the over-voltage/under-voltage protection circuits as well as the output over-current/over- heat protection circuits were designed. The inverter power source has advantages of high reliability， simple structure，small size，etc. Keywords: SG3525 control；two-stage inverter；PWM；protection circuit 0 引 言