开关电源1234（Switch power supply 1234）.docVIP

开关电源1234（Switch power supply 1234） General considerations for switching power supply design Switching power supply, design Before designing switch power supply, the power supply technical requirement should be studied carefully. An example of a communication power module is presented to illustrate the design considerations. The technical specification of this module is as follows: 1 electrical properties Unless otherwise specified, all the parameters in the input voltage is 220 v, ac 50 hz, and environmental temperature 25 ℃ under test and the rules. 1.1 input Voltage: single phase ac rated voltage effective value of 220V plus or minus 20% Frequency: frequency range 45-65hz Current: at full load, enter 220V, less than 8A. At 264V, the shock current is no greater than 18A Efficiency: the load is 50% - 100% table 2.1 Power factor: greater than 0.90, load above 50%, above 0.95 Harmonic distortion: meets the requirements of IEC 555-2 Start-up delay: the output reaches its rated level in 3 seconds Maintain time: enter 176V effective value, full load, greater than 10mS 1.2 the output Voltage: when fully loaded, the output voltage is set at + / -0.2% of the table 1 value Current: load current from zero to maximum (see table 1). Flow protection starts with constant current. When the voltage is reduced to a certain value, the current is closed. Voltage stabilizing feature: load change from zero to 100%, input voltage from 176V to 264V, the output voltage change not exceeding 200mV. Transient response: when no battery is connected to the output terminal, the load is changed from 10% to 100%, or 10% of full load change, and recovery time should be within 2mS. The maximum output voltage deviation should be less than 1V. Static leakage current: when the module is off, the maximum reverse leakage current is less than 5mA. Temperature coefficient: the module is within the total working temperature range of less than 0.015%. Temperature rise drift: in the first 30 seconds, plus or