热电偶与热电阻的区别（The difference between thermocouple and thermal resistance）.doc

下载文档 降价啦

6
0
约1.2万字
约 8页
2017-07-21 发布于河南
举报
版权申诉
保障服务

热电偶与热电阻的区别（The difference between thermocouple and thermal resistance）.doc

1、本文档共8页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

热电偶与热电阻的区别（The difference between thermocouple and thermal resistance）

热电偶与热电阻的区别（The difference between thermocouple and thermal resistance） One, the difference: 1. Although is non-contact thermometer table, but their different temperature range, thermocouple used in high temperature environment, such as platinum rhodium 30 - platinum rhodium 6 (B) measuring range is 300 ~ 1600 degrees, 1800 degrees short-term measurable. The s-type measurement is one 20 ~ ~ 1300 (short-term 1600), the K type measuring one 50 ~ ~ 1000,? (short-term 1200). The XK type is 50 ~ ~ 600 (800), and the E type is 40 ~ ~ 800 (900). Theres the J, the T, and so on. This type of meter is generally used in high temperature over 500 degrees, because they are in the low temperature zone thermoelectric potential output is small (we can have a look at the table), when the potential hours, against interference measures and the second table and requirement is high, otherwise the measurement, and, in the region of the low temperature, the change of the cold end temperature and the relative error caused by the change of environmental temperature is very outstanding, is not easy to get full compensation. At the middle and low temperature, the temperature range of thermal resistance is a range of 200 ~ ~ 500, and even lower temperature can be measured (such as using carbon resistance to measure the low temperature of 1K). Now normal use Pt100 platinum thermal resistance, (also have Pt50, 100 and 50 representative at 0 degrees of resistance, thermal resistor in the old index number with BA1, BA2, BA1 at 0 degrees for 46 ohm resistance value, useful also copper resistance in the industry, index number is CU50 and CU100, but small temperature range, between the 50 ~ 150. In some special occasions and indium resistance, manganese resistance? Etc.)? 2. The basic principle of thermocouple measurement is thermoelectric effect. The second table is a voltmeter or an electronic potentiometer to improve the accuracy. Resistance is based on the properties of conductors and semiconducto