dfgdfgd（dfgdfgd）.docVIP

dfgdfgd（dfgdfgd） Specific Settings are as follows: Admin, password input: admin, This article takes the di-740p model of the broadband router d-link, the default management address is , and the management port is 8080. Will the IP address of a computer and the router management address set in the same network segment, such as , open computer browser, enter :8080 in the address bar and press the enter key or a user login prompt window, enter in the broadband router manual management account and password to enter setup interface by default. In order for the router to dial automatically, we also need to integrate the ADSL account into the router. Click the first page TAB at the top, then click WAN to change, see the place of setting ADSL account in PPP over Ethernet, enter the ADSL account and password of your application and save the Settings. Now go to the system information in the system status TAB to see the network status, and you can clearly see the network information that ADSL dial-up is available on the WAN end. After setting the ADSL account, we can through the Internet broadband routers, but in order to better manage and improve security also need the following: click on the home page TAB, and then select DHCP on the left, in a setting can enter the DHCP servers IP range IP address range, saved the broadband router will have the function of automatically assign IP addresses. Im not going to do this By default, all computers connected to the router are protected, meaning that p2p software, such as bt, will be affected by the use of bt. We can set up the declared host with the DMZ in the advanced Settings TAB. Exposed in the network is to set the host here, on the one hand, can be used without fear to bt download software and the establishment of iis, FTP server, etc., on the other hand also exposed before hackers and virus, so the security of the computer work must be done well. (if only to use p2p software such as bt and the words of the host is very unwise