DBX声明书（DBX statement）.docVIP

DBX声明书（DBX statement） Front panel operation button PREV PG previous page NEXT PG, next page EQ equalizer settings. Continuously and on time, select the input part of the icon to balance the GEQ and output parts. The parameters of each channel are balanced by PEQ SUBHARMONIC actuator settings XOVER divider settings FEEDBACK feedback suppression settings COMP/LIMITER compressor or limiter setting DELAY delay setting PROGRAM programming model UTILITY multipurpose menu STORE program storage The WIZARD wizard settings include SYSTEM SETUP system settings, AUTO, EQ, automatic EQ, and AFS automatic feedback suppression Two, the use of methods 1, select procedures Turn on the power and rotate the DATA data wheel select program. The factory program FACT does not necessarily meet requirements. You can select a program in the user program USER as required. 2, system settings Press the WIZARD key, the light is on, and the display screen displays the Sysrem Setup system setup interface. Press the NEXT PG key or data wheel to enter the Input Setup input settings, rotate the data wheel, select the MONO mono or STEREO stereo input. Press NEXT PG again to enter the GEQ icon equalization setting, and the rotating data wheel is set to double mono or stereo application status. Press NEXT PG again, enter the Main Speaker main speaker, rotate the data wheel, and select the speaker type you use. If the model is not available, select the last Custom, the user. Press NEXT PG again, and then enter the Sub, Speaker woofer and high, medium and bass channels, power amplifier models and their input level settings. If the model is not available, select the last Custom, and then there is no input level setting. After all settings, and then press the NEXT PG key, it prompts Load, New, Program load new procedures, then click the data wheel, show Loading Finally, prompt Program Loaded, the program is loaded, the system settings are complete, and press PROGRAM to exit the system settings. 3. Adjust in