CAD三维画图教程（CAD 3d drawing tutorial）.docVIP

CAD三维画图教程（CAD 3d drawing tutorial） In this paper, by Yan Manchu if contribution DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. AutoCAD 3D modeling tutorial series A cuboid, three-dimensional array, difference set by [duotu] [D] 06 exercises The main topics are: 1, the three-dimensional entity command cuboid use. 2, the use of three-dimensional array (rectangular array). 3, two bit frame hidden command, and the use of multi-layer entity difference set. In three-dimensional operation, often use the hidden command in CAD 2 hidden command, they are different in use, one is hidden in the fire command, three-dimensional coloring also belongs to 3D blanking. There is also a two-dimensional wireframe model of hidden, in practical operation more practical, and command better, remember HIDE, and there is a quick command HI. Here is a basic introduction to the 2 commands: View original (larger) View original (larger) Here is a detailed drawing of the exercises: 1, open the CAD, click on the Southwest isometric view button, interface to Southwest view.. View original (larger) 2. Draw a cube with the cuboid. The length of the cube is 50. View original (larger) 3, in accordance with the beginning of the hidden essentials, enter the Hi, the generation of hidden map, as follows. In the fire In the state of the hidden graph, the operation is convenient. Look at the original picture (big picture), or draw a small cube with the cuboid command. The length of the cube is 10. The corners of the small cube are at the bottom of the large cube, as shown in the following figure. Read the following article editing selection AutoCAD 3D modeling tutorial series: rectangular and round commands by using AutoCAD three-dimensional modeling tutorial series: 3D rotation, cutting, array by using AutoCAD three-dimensional modeling tutorial series: stretch difference sets and chamfering using AutoCAD