安卓下a2sd命令详解.docxVIP

本文由niufox整理，转载请注明（一）0312birdzhang转载[ ] Apps2SD is launching...__ _____| \ | | | | |__/ | Darktremor Apps2SD 2.7.5.2 (2010-09-30)[ ] GetProp Command = /system/bin/toolbox getprop[ ] SetProp Command = /system/bin/toolbox setprop备注：运行时必须在前加上a2sd 命令例如：开启jit 运行： #a2sd jit[ ] Mount Point = /sd-ext[ ] Starting Darktremor Apps2SD Version 2.7.5.2[X] No command specified. You must specify a command if you are launching from the command line.Syntax: /system/bin/a2sd commandAll commands create a logfile: /data/dta2sd.logCommand is one of the followingStandard Apps2SD Commands:Apps2SD基本命令reinstallreinstall Moves free and paid apps to the ext2/ext3/ext4移动软件到ext分区，删除noA2sd标识文件 partition on your secure digital card. Removes the No A2SD flag file. This is used if you have already executed an这个主要用在你运行了删除 a2sd 命令 a2sd remove command. Otherwise, this part is automatically performed when Apps2SD is started. File removed: /data/.noa2sdremoveremove Moves free and paid apps to the internal phone移动软件到手机内存，并建立noA2sd标识文件 storage. Creates the No A2SD flag file. File created: /data/.noa2sdSwap Partition Commands:Swap 分区命令 reswapreswap Removes the No Swap flag. Allows A2SD to 删除noswap标识，允许A2sd激活swap分区 activate the swap partition. This is used if you have already executed an a2sd noswap command. Otherwise, this part is automatically performed when Apps2SD is started. File removed: /data/.noswapnoswapnoswap Creates the No Swap flag. Prevents A2SD from建立noswap标识，防止A2sd激活swap分区 activating the swap partition. File created: /data/.noswapswappyxxswappyxx Sets swap partition swappiness value to xx. 设置swap分区swappiness数值为xx例子：设置swap分区swappiness数值为30%，输入a2sd swappy30，设置为75%，输入a2sd swappy75 Example: To set the swappiness of the swap partition to 30%, type: a2sd swappy30 To set at 75%, type: a2sd swappy75 File created: /data/dtswapDalvik Cache Commands:Dalvik 缓存命令 cachesdcachesd Moves Dalvik cache files to the ext2/ext3