捷达abs问题（Jetta ABS problem）.docVIP

捷达abs问题（Jetta ABS problem） How can the Jetta ABS light be solved? Tan Bing about your questions, ABS lights and many factors, ABS speed sensor is mud, mud and other pollution sources covering, affect the speed sensor signal corresponding to the ABS computer, can not determine speed, can not determine the slip ratio of the wheel, and then cant make corresponding action instructions to adjust the brake, this time as long as clean the dirt on the vehicle speed sensor, speed sensor and signal gap adjusting ring gear, can be restored to normal; the speed sensor damage after ABS light, then we must replace the ABS sensor; secondly, the ABS line between the loose connection, ABS pump failure, can also lead to the ABS lights, the need of fault to conduct a comprehensive inspection. About your questions, first to detect the wheel speed sensor resistance, the resistance value is normal, there is no ground phenomenon, if these problems are normal, the sensor is normal; then the gap detection sensor, remove sensor, the sensor head has not been serious wear, indicating that the sensor gap is improper, the sensor tip and ring gear friction, and the issue of abnormal sound. Check the fault code to control the solenoid valve and hydraulic pump failure, should be suspected of fuse problems, check the power supply of ecu. ABS lights flashing, mostly ABS self diagnosis, incentive interface has been inserted fuse, so that the ABS into the self diagnosis caused by the state. From the junction at ECU detection terminal, the line is at the ground. Along the line search, whether in the relay box at the line was worn and ground. Check tire speed sensor, dirt or plug must be connected; ABS control unit is faulty or wiring must be connected; ABS system crashed after the computer did not match; tire speed sensor ring is damaged. It is also possible that the vehicle runs in a rainy day, due to water, dust, raindrops splashed on the chassis, resulting in adhesion and barrier function, the ABS se