LCD1602简单显示程序(单片机).docxVIP

#include reg51.h #define uchar unsigned char #define uint unsigned intsbit LCD_E=P3^5; //定义接口sbit LCD_RW=P3^6; sbit LCD_RS=P3^7; #define LCD_Data P1 //数据接口uchar up[]={IvU,hupeixian};uchar code down[]={_by fu }/*************************延时函数*****************************/voidDelay_ms(uint time){uinti,j;for(i = 0;i time;i ++)for(j = 0;j 930;j ++);}/**********************检测状态************************************/ucharLCD_ReadStatus(void) { LCD_Data = 0xFF; LCD_RS = 0; LCD_RW = 1; LCD_E = 1; LCD_E = 1; LCD_E = 0; while (LCD_Data 0x80); //检测忙信号return(LCD_Data); }/************************写数据***********************************/voidLCD_WriteData(uchar WDLCD){ LCD_ReadStatus();//检测忙LCD_Data = WDLCD LCD_RS = 1; LCD_RW = 0; LCD_E = 1;//若晶振速度太高可以在这后加小的延时LCD_E = 1;//延时LCD_E = 0;}/************************写指令********************************/void LCD_WriteCommand(ucharWCLCD,BuysC) //BuysC为0时忽略忙检测{ if (BuysC) LCD_ReadStatus(); //根据需要检测忙LCD_Data = WCLCD; LCD_RS = 0; LCD_RW = 0; LCD_E = 1; LCD_E = 1; LCD_E = 0; }/*****************初始化***********************************/voidLCD_Init(void) { LCD_Data = 0; LCD_WriteCommand(0x38,0);//三次显示模式设置，不检测忙信号Delay_ms(5); LCD_WriteCommand(0x38,0); Delay5Ms(); LCD_WriteCommand(0x38,0); Delay_ms(5); LCD_WriteCommand(0x38,1); //显示模式设置,开始要求每次检测忙信号LCD_WriteCommand(0x08,1); //关闭显示LCD_WriteCommand(0x01,1); //显示清屏LCD_WriteCommand(0x06,1); // 显示光标移动设置LCD_WriteCommand(0x0C,1); // 显示开及光标设置}/***********************显示一个字符********************************/voidDisplayOneChar(uchar X, uchar Y, ucharDData){ Y = 0x1; X = 0xF; //限制X不能大于15，Y不能大于1 if (Y) X |= 0x40; //当要显示第二行时地址码+0x40; X |= 0x80; // 算出指令码LCD_WriteCommand(X, 0); //这里不检测忙信号，发送地址码LCD_WriteData(DData);}/************************显示一串字符************