手掷模型飞机的调试与飞行（The commissioning and flight of hand throwing model aircraft）.docVIP

手掷模型飞机的调试与飞行（The commissioning and flight of hand throwing model aircraft） The commissioning and flight of hand throwing model aircraft Before the flying of the model aircraft was made, we first debug the model. Different types of model debugging methods are different, and hand throwing model aircraft debugging is the procedure: 1, counterweight, adjust the center of gravity Attach weights to the nose. The best matching object density larger, we use the wire used to accompany the heavy. Check whether the counterweight is right: the center of gravity should be 1/3 feet from the front of the wing, and then adjust the center of gravity of the aircraft by hand. The main observation is that the model flight after the flight. (teach students throw the essentials; head light, head judge model method) 2, flying 1, straight distance subjects flight How to adjust the flight line: when the model is always time to one side of the yaw rudder, we can be in the opposite side, a little a little. When you hand, the angle between the ground and the ground should be appropriate. 2, blank time flight subject In order to make the model in the right radius circle, when the model circle radius too small, can be changed by adjusting the rudder model; to the side of a sharp spiral, can be adjusted by adjusting the rudder or method of wing tip on the opposite side of the appropriate weight. A better design, a more careful hand throwing the aircraft, if not adjusted, can not play its flying performance, so we must learn to adjust the method. Flight adjustment must be done before each flight, and the flight adjustment must also be done again when the hand cannot throw the aircraft well. The flight adjustment process can be divided into three steps, namely, adjusting the center of gravity, trial slip and trial throw. The center of gravity of the hand tossed aircraft is not correct, which will affect the flight performance. To measure the position of the center of gravity, use tweezers or scisso