串气和倒液（Pour the liquid and gas mixing）.docVIP

串气和倒液（Pour the liquid and gas mixing） Also known as CO2 refers to the backflow leakage liquid pipe keep liquid seal disappear or synthetic tower level in the production process to not timely treatment caused CO2 synthesis from the tower liquid outlet pipe into the high pressure scrubber synthesis tower feeding process. Pour the liquid to stop the synthesis tower full liquid, cause the gas tower full liquid, and because of the siphonage function, the liquid level does not come down 3# published in 2009-2-4 12:37 | only the landlord said should be the carbon dioxide stripping urea plant problems. In the process of driving, because the synthesis tower liquid control valve HV201 will not die, the overflow pipe liquid seal disappears, the CO2 takes the short circuit, namely enters the synthesis tower directly, and occurs the dangerous phenomenon. The main control method is to look at the temperature of the TI205 point on the overflow pipeline. Once there is a big change, we should immediately flush the liquid and seal the liquid. In the parking process, the CO2 shall continue feeding the system for about 5 minutes to prevent the occurrence of reverse fluid. That is to prevent the material in the tower from turning into a high pressure ammonium carbamate condenser. At the same time, but also to mention the pressure of PC206, that is, 0.4MPa pipe network steam pressure is about 0.5MPa. In addition, the normal and the production process of the CO2 string into the circulatory system, CO2 short circuit accident of the heating go passivation process, while the former harm to the equipment and operation is quite dangerous, to strictly control the level of aerobic reactor and stripper. 4# published in 2009-2-4 12:45 | only see the author Im in the solution total recycle urea production here prone place is there will be a tower or full liquid gas channeling phenomenon 5# published in 2009-2-4 12:59 | only see the author mentioned in the 3 floor the landlord said should be the car