信号线连接（Signal line connection）.docVIP

信号线连接（Signal line connection） Computer motherboard jumper how to tune, connect the chassis? The four plug of the PC horn is actually only 1, 4, two wires, and the line is usually red, It is attached to the main board Speaker pin. This is marked on the motherboard, usually Speaker. In the connection, note that the red line corresponds to the position of 1 (Note: red line corresponds to 1 position - some boards will be marked as positive 1, and some labeled +, as appropriate. The RESET connector connects to the RESET key of the case, and it should be connected to the RESET pin on the mainboard. The function of the RESET pin on the motherboard is this: when they are short circuited, the computer restarts. The RESET key is a switch that causes a short circuit when it is pressed. When the hand is released, the circuit opens again, and the short circuit of the clock restarts the computer. Occasionally this happens when you press the RESET button and release, But it didnt bounce, kept short circuited and the computer restarted. ATX structure of the chassis there is a total power switch wiring, is a two core plug, and it is the same as the Reset, short when pressed, Open the door when you release it, press it, the main power of the computer is connected, and then press it to close, But you can also set it in BIOS to turn on the power button and turn on the switch for more than four seconds, Or simply can not switch off, and only rely on software shutdown. The three core plug is the wiring of the power indicator, Use 1, 3, and 1 lines, usually green. On the motherboard, the pin is usually marked Power. When connecting, watch for the green line corresponding to the first pin (+). When it is connected, when the computer is turned on, the power light is on all the time, indicating the power has been turned on. Two core connector of hard disk indicator lamp, The line is red. On the motherboard, such pins are usually labeled IDE LED or HD LED, and the connection should be red lin