佳明 garmin 410 快速使用说明书(佳明 garmin 410 快速使用说明书).docVIP

  • 135
  • 0
  • 约5.55千字
  • 约 9页
  • 2017-07-25 发布于河南
  • 举报

佳明 garmin 410 快速使用说明书(佳明 garmin 410 快速使用说明书).doc

佳明 garmin 410 快速使用说明书(佳明 garmin 410 快速使用说明书)

佳明 garmin 410 快速使用说明书(佳明 garmin 410 快速使用说明书) Instruction manual for Ming forerunner 410 Use induction bevel An inclined surface on the surface of a watch is equivalent to a multi-function button A finger lightly touch the table: inclined to make a choice, such as the menu, or page Press: press the finger in the four mark area to change the mode Double press: two fingers press two mark areas at the same time to open the backlight mode Slide: tilt and slide on the slope to select the menu option or to increase or decrease the value 1 time/date: press and hold enter time / date mode Press 2 GPS: and stay in GPS mode 3 menu: press and hold on to the menu page 4 training: press and keep in training mode 5 start/stop/enter: Press start or stop time in training mode Press down to make a choice Press exit to save mode Press and hold the watch open 6 lap/reset/quit: Press to set up a new paragraph in the training mode Press and hold the reset time and save the activity Press the Exit menu or interface Press exit to save mode Cant notice Hold down the slope The bevel is the outer ring of the word in the meter, not the inner ring near the surface Each action on the slope makes a choice Use your finger while youre using it Use bevel without gloves Lock bevel In order to avoid accidental tap, while pressing the enter and quit need to unlock lock slope, while pressing the enter and quit Power saving mode For long periods of time, the device automatically enters the power saving mode. In the following cases, the device does not move. For example, when the table time is gone, the navigation interface is not available and the ramp is not used Close To save power, you can turn off your watch without using your watch 1 press Menu select Settings system shutdown 2 select Yes Press enter to turn on the watch Charge In order to protect the battery, the initial state of the device is not charged, and the charge must be charged for at least three hours before the first use Note: to avoi

文档评论(0)

1亿VIP精品文档

相关文档