协转和收发器（Co rotating and transceiver）.docVIP

协转和收发器（Co rotating and transceiver） Coordinating section Fill in the blanks 1, there are two major international PDH systems, namely European standards and American standards, and their basic speed is _2.048Mbps and 1.544Mbps respectively. 2.048Mbps is adopted in our country. 2, give the Chinese interpretation of PDH (quasi synchronous digital sequence), the Chinese interpretation of SDH (synchronous digital sequence). 3, in accordance with the user side interface and the transmission side of the interface, the main transfer is divided into (Ethernet), E1 (E1), (V.35) transfer. 4, in E1 frames, the main function of TS0 is to transmit frames, locate signals, manage network information, alarm and so on. 5, DDF frame and ODF frame in function difference is (the former is cable jumper frame, the latter is fiber optic jumper frame) Answer: the former is the cable jumper frame, which is the jumper of optical fiber cable 6, if the co rotating CRC checksum does not match the CRC checksum of the router, there will be a regular packet loss phenomenon. 7, a protocol converter with reverse multiplexing, the chip that plays a bridge between the Ethernet chip and the E1 chip is (FPGA) 8, in E1 frames, the main function of TS16 is to transmit channel signaling, frame alignment signal, alarm, and so on. 9, DTEs Chinese explanation is (data terminal equipment), DCEs Chinese explanation is (data communication equipment). 10. The terminals of the DC power supply are divided into -48V, PGND and BGND. During construction, the -48V is connected with the DC power supply (-48V), the PGND connection (protection ground), and the BGND connected to the DC power supply (0V). 11, RC905/6-EE1 Ethernet port default duplex mode to auto negotiation fails to work in (half duplex) mode, and other equipment in the docking port duplex negotiation failed, to confirm the two equipment duplex mode, otherwise the business. 12, when the RC903-V35FE1 device is not framing at the primary timing, the AIS signal