修光圈（Fix the iris）.docVIP

修光圈（Fix the iris） Repair the aperture (reproduced) 2012-05-15 16:57:13| classification: classification | Tags: | default font and subscriptions. Aperture stability test Customer requirements for lenses are getting higher and higher, and how to keep the aperture steady in the process, without affecting operation efficiency, without increasing costs and ensuring quality. Now its a hot topic for discussion. Therefore, the representation of representative (representative, surface shape precision, difficult to process, local error strict) parts, to find the basic conditions of the stability of the aperture. I. unstable iris reference 1, processing conditions: 1) the size of abrasive powder particles, and the concentration ratio of the size of the aperture effect; grinding powder particle size is too large and the concentration is too large, the greater the radius of curvature change of grinding plate, (convex dish radius of curvature; concave dish radius of curvature smaller) as compared with water, aperture to change the direction of the high vertical edge; easy to cause. 2) the speed of the impact of the local aperture is irregular, the edge of the edge of the grinding line speed is different from the central line speed. Put more edge grinding plate lens, the lens aperture is negative to the aperture change; can be caused by the lens center and the edge is not balanced wear, low and high, and is transferred to the lens out of this truth. 3) the magnitude of the pressure has a direct effect on the lens of the center thinner and D/T 10, which is especially evident in the use of string bars. The effect of the pressure on the shape of the lens is mainly caused by the uneven force of the whole surface of the lens. 4) the processing time also affects the change of the surface shape accuracy. Because the grinding follows the cosine grinding, the radius of the radius of the grinding plate depends on the sand and the finished product is corrected at any time. (because the radi