压降（pressure drop）.doc

压降（pressure drop） Pressure drop: that is the descent of the potential. The definition is this: the difference in electric potential between two points in a circuit is called the voltage between these two points. Potential drop is called voltage drop. For example: A voltage point (PD with 0 potential) is 5V, voltage B is 8V, then A to B point, is the pressure drop is 3V. Or stand at the B point, say A, that is, the pressure drop is 3V In the LED LED circuit, we know the LED forward voltage drop UF=1.4V, the forward current IF=10mA and the supply voltage 5V. How can we determine the current limiting resistor? (5-1.4) /10=0.36k Omega Can you tell me if there are 10 led LEDs, the voltage is 3.2v-3.4v and the current is 10ma-20ma.. How do you connect them to the 5V voltage of the notebook USB? How much resistance does it take? Is it a buck resistor or a down flow resistor? Trouble answer, eh? Also known as Buck resistance, but also said the current limiting resistor, usually with 300 ohm resistance is very bright. You use 120 ohm resistor, notebook power supply also cant stand, the luminous tube is bad also fast. Question, then, how many ohm resistors do I need to use? The answer is between 220 ohms and -300 ohms. It cant be any smaller. You put a resistor on a LED, and then use a mouse line with a USB plug, and put them together and attach them to the red and black lines. If you turn it back, itll turn on. 54 LED lights (LED is 3.2-3.6V, 20MA), all and then connected to the 5V USB battery box (that is, section 5, No. 4 batteries), need to string a number of resistors? 54 LED lights (LED is 3.2-3.6V, 20MA), all connected in parallel, and then connected to the 5V USB battery box (that is, section 5, No. 4 batteries), need to string a number of resistors? The best way to teach fish is to teach me how to calculate. Thank you! The current 54*20MA=1.08A LED resistance of 3.6 / 1.08 = 3.6. The partial pressure of resistance (5-3.6) / 1.08 = 1.4 series resistor power P = UI = 1