deh自动保护系统（DEH automatic protection system）.docVIP

deh自动保护系统（DEH automatic protection system） Automatic protection system, 1-3 DEH The following is the action logic diagram of the DEH automatic protection system and the schematic of the actuator. The main actuator emergency trip system comprises a four automatic stop trip solenoid valve (20/AST) and two overspeed protection solenoid valve (20/OPC) of the emergency stop control block (or solenoid valve), diaphragm valve and pressure switch, etc.. Speed protection control system (OPC) 1: role: when the unit in 30% load above the operation of oil switch trip, or speed n 103%n0, through the OPC solenoid valve quickly closed high and medium pressure regulating valve, n 103%n0 recovery. 2, main components: OPC solenoid valve, two parallel, is speeding protection, control solenoid valve, they are subject to the OPC part of the DEH controller. The normal operation of the solenoid valve two is not charged normally closed, closed discharge channel OPC oil duct, the actuator piston cavity regulating steam valve and reheat steam valve regulating the oil pressure can be set up, once the OPC control board action, such as speed up to 103% of the rated speed, the two solenoid valve it was exciting (electricity) to open the oil discharge pipe OPC. Thus, the unloading valve on the actuating mechanism is quickly opened, so that the regulating steam valve and the reheat regulating steam valve are rapidly closed. 3, action process: when the unit is running oil switch trip at 30% load above, or speed n 103%n0, OPC action solenoid valve, pressure relief duct blocking off OPC, through the rapid unloading valve quick closing high pressure regulation valve; when the speed dropped to n 103%n0, close OPC relief valve the oil inlet pressure recovery OPC blocking duct, the high and medium pressure regulating steam valve open to adapt with the load position. 4 significance: to prevent the unit from speeding because of load rejection or other reasons, to avoid the unit restart due to stop, mai