纯压圆弧形钢管桁架拱平面内稳定性能和设计方法_郭彦林.pdfVIP

31 8 2010 8 Journal ofBuilding Structures Vol131 No18 Aug12010 007 : 1000-6869( 2010) 08-00 5-09 郭彦林, 郭宇飞, 窦 超 (清华大学土木工程系, 北京 10008 ) : , , , , , , , , , : ; ; ; ; ; : TU3931302 : A In-plane buckling and design of two-h inged steel tube circular truss-arches under pure compression GUO Yanlin, GUO Yufe,i DOU Chao (Departm ent of Civil Engineering, TsinghuaUn iversity, Beijing 10008 , China) A bstract: Until recently, the corresponding stab ility design m ethod is absent for the lack of researches on the in-plane stability and load-carrying capacity of steel tube truss-arches. In this paper, firstly the expression of sectional shear stiffness is proposed, and the buckling loads and modified slenderness ratio of two-hinged circular arches under pure compression are derived, considering the effects of sectional shear deform ation on buck ling behavior. Secondly, by adopting finite elem ent numericalm ethod, the buckling analysis of a pure compressive arch is carried out to investigate the influence of different param eters on the elastic buckling behavior of planar and spatial truss-arches, such as sectional height-to-w idth ratio, rise-to-span ratio, web-m ember included angle and sectional dmi ension. It indicates that the buckling loads calcu lated by the formula derived above are in good agreem entw ith num erical results. Finally, referring to the stability design m ethod of solid w ebs arch and latticed columns in current Ch inese code for steel structures, by elasto-plastic fin ite elementm ethod the interactive ultmi ate load-carrying capacity of pure compressive truss-arch is studied, considering the influence ofmember local buckling on global stability. It is found that the ratio betwe