浆砌石（Masonry）.docVIP

浆砌石（Masonry） Construction units shall not take raw materials for construction. Otherwise, the consequences will be the responsibility of the construction unit. Fficeffice / 2, the masonry masonry construction should be the acceptance batches to the laboratory building notice, is strictly prohibited without the list of ingredients and ingredients without construction, masonry construction unit mortar should be strictly in accordance with the list of ingredients according to the measurement, measurement or measurement of the list of ingredients, or mixing uneven, can not ensure the strength of mortar meet the design requirements the punishment for the responsible department. 3, retaining walls should be divided into leather, lying, masonry, up and down the wrong seam, internal and external lap, shall not use the side of the stone side, the middle filling method. Mao Shiqiang must be set to tie the stone, and should be evenly distributed, staggered; rubble middle thickness of not less than 20cm. Each layer of 3-4 leather for a hierarchical height, each layer should be leveling once, two layers of staggered joints shall not be less than 80mm. If it fails to meet the above requirements, the responsible department will be punished and ordered to be ordered to rectify and reform. 4, retaining walls should be 20-30mm thickness of mortar, mortar should be full; larger gap between the stones should be filled with mortar, and then crushed stone block, and shall not be used to plug stones, fill mortar or dry gravel filling method. Any violation of the provisions of the above will be punished by the responsible department and ordered to rectify and reform. 5, the masonry retaining wall surface for tiger stone, tiger stone requirements surface with artificial chiseled stone surface smooth, straight lines cut, and the spacing is 40mm, but each stone surface texture chisel spacing must be consistent between the parallel lines cut. Stone edges should be trimmed into polygons, to en