5055常见故障（5055 common failures）.docVIP

5055常见故障（5055 common failures） Common failures: Fault 1: suddenly initialized or initialized Treatment: It is possible to measure whether the dc voltage of the MCON board TP - AC and TB6 is in the 4.8-5.3 V range, if no VRI is adjusted for the PSI panel. The main board failure (MCON board) is likely to check the motor and insurance. Failure 2: reporting Machine eror15 error Treatment: 1) check the laser: observe the light path in the darkroom for light (usually) high DPI (3000, 2400) when the output error after only a short light, with low DPI (1000, 2000) to output about A4 image disappear after light and an error. Usually this is a laser head failure. Check the laser sensor (Star sensor) if there is light and error. Check if the Star sensor sensor is in the wrong position or if there is something dirty. (3) MACON plate. Failure 3: image distortion Treatment: The light of the five-sided mirror is unstable and jumps. Unstable parts are not in place when the parts are installed. The long parts wear out. The figure of TIF is over 100m. Failure 4: report Machine error17, 18, 19, or Load error error Treatment: Front slack guide motor. Check the status of Front slack roller position to see if the position is incorrect. Failure 5: the black line (the direction is horizontal) Treatment: As the roller is dirty, it can be wiped clean. The ground line is not good, the roller generates static electricity. There is a large voltage difference between the working voltage. The data transmission is not stable (the memory, the issuing card, the hard disk will have an impact). Failure 6:5055S (Film jam 5) error Treatment: (1) turned to the feed box, film into dont go, when in the feed box, the machine began to turn, if the last heard cut, the machine must be card, adjust the location of the feed box on the right side of the aluminium plates. The supply box rack is deformed. The machine has no level Failure 7:5055 Film jam 4 wrong Treatment: The machine has no level. The film did not