CAD考试题（CAD test）.docVIP

CAD考试题（CAD test） AutoCAD textual research simulation test (2) Single topic selection: 1. When the chamfer is used for chamfer operation, C A, cant reverse the multi-segment line object B, the object of the spline curve can be inverted C, cant reverse the text object D. Cant reverse the three-dimensional object 2. The number of array objects and distribution methods are not defined by the ring array: C A, total project total and fill Angle The Angle between the total number of projects and the project C, total number of projects and base points D, fill Angle and project Angle 3. Move the circle object to move its center to the midpoint of the line and need to be applied: D A, the orthogonal B, capture, C, grid D. Object capture 4. Rotate the object with rotate command: B A, the rotation Angle must be specified B, the rotation base must be specified C, you must use the reference mode D, can scale objects in 3d space 5. Scale object with the zoom command: D A, you must specify A scaling factor B, you can not specify a pinch point C, you must use the reference mode D, can scale objects in 3d space 6. When stretching the object of stretch, you cant: A A. Stretch the circle to an ellipse B, stretch the square to the square C. Special points for moving objects D. The overall moving object 7. There are many options when you elongate the lengrhen to modify the length of the open curve except: B A, incremental B, closed C. Percentage 8. The object to be pruned by the trim command trim is: D A, the circular arc B, round C, linear D, 9. In AutoCAD, the CAD standard file suffix is named: A A, DWG B, DXF C, DWT D, DWS The round Angle command of fset is used for a multi-segment operation: B A, you can specify the radius of the different corners at one time B, if an arc segment separates two intersecting lines, the segment will be deleted instead of the rounded corner of the specified radius C. Each meeting must be assigned separately D, the radius can be arbitrarily specified 11.