开机方面（Boot in）.docVIP

开机方面（Boot in） The following methods are for reference only 1. Unable to turn on (i.e. press the power button without any reaction) I believe the first thing that comes to mind is power. Yes, power is the most direct cause of this problem. But in addition to the power supply, do you know that when the main plate is damaged, this problem also arises? The main board has a north-south bridge (the n-series integrated motherboard has only one chip), and when the north-south bridge chip is damaged, it may cause a failure. The second is the jumper, which is the power switch. This is generally easy to overlook, and I also stumbled upon it. Because you dont think the switch will be bad. Only once I pulled out the jumper and touched it with a screwdriver, so it was ok, and I couldnt open it when I plugged it in, so I found it. The most overlooked thing is that the motherboard battery is dead! In general impression, the mainboard battery has no electricity at most is the BIOS time restore and information is not saved, actually otherwise. A lot of motherboards, especially old motherboards, the motherboard battery had no power and couldnt get on the machine, and a new one was immediately good, which was also discovered by accident. At the end of the day, there may be too much dust, and the conductive part of it is connected to a similar spot on the motherboard. So when the machine is not open, dont just think that the power supply is broken, to check in many ways. 2. It can be turned on, but only the main machine is energized without any signal In this case, it is usually the contact problem. If the machine does not call the alarm, or the test card displays 00 or FF, and the power lamp and the hard disk light remain on, it is the problem between the CPU and the motherboard. Maybe its not touching, maybe its CPU bad, maybe its about 75% of the motherboard is broken, its not true. If you have the conditions and supplies, try it. But generally speaking, contact is the most likely to