计算机速度（Computer speed）.docVIP

计算机速度（Computer speed） Here are some of the Settings to improve the boot speed. I used 1, 2, and 5, and I started with less than a lap to get into the system. Disable idle IDE channels Acceleration principle: since Windows XP system will automatically detect the IDE on the computer during startup, the detection of idle IDE channels will be closed to speed up the system startup. For Internet myth, however, need to correct: many people think simply idle IDE channel can be disabled in the BIOS, and suggest in the BIOS and at the same time also closed in the system. First, the first approach is fundamentally ineffective, because XP operating systems can bypass the motherboards BIOS independently to monitor the various states of computer hardware; And then theres a way of looking at it. Therefore, it can only be closed in Windows XP system to effectively disable idle IDE channels. 【 approach is as follows: right click on the my computer - properties, then click on the hardware and then click on the device manager, in which open the IDE ATA/PATA controller (slightly different different chip), and then enter the primary and secondary IDE channel respectively, choose the advanced Settings, find the current transmission mode for a not applicable (which is corresponding idle IDE channel), will be the device type set to no, sure. 2. Set the IP address manually Acceleration principle: Windows XP is developed on Windows 2000 and supports rich network functionality. In the Windows XP system will automatically detect the computer after boot whether links to local area network (LAN), but the average user is single machine to the Internet, and basically in the network connection Settings are to obtain IP address automatically. Thus, the system will search the DHCP server for assigning an IP address to the machine, but the average user will not be configured at all. This can make after every boot, the system will take a long time to search the DHCP server will stop until obtain IP add