2011 Standard for Performance Rating Of Water （2011性能评级标准的水）.pdf

ANSI/AHRI Standard 550/590 (I-P) with Addendum 3 2011 Standard for Performance Rating Of Water-Chilling and Heat Pump Water-Heating Packages Using the Vapor Compression Cycle Approved by ANSI on June 18, 2012 AHRI STANDARD 550/590 (I-P)-2011 WITH ADDENDUM 3 Performance Rating of Water-Chilling and Heat Pump Water-Heating Packages Using the Vapor Compression Cycle September 2013 Addendum 3 (dated September 2013) of AHRI Standard 550/590 (I-P)-2011, 鈥淐hanges to AHRI Standard 550/590 (I-P)- 2011 鈥 is provided as follows. The following changes have been incorporated (deletions are shown by shading in red, additions are shown by shading in gray) into the already published 2011 version of AHRI Standard 550/590 (I-P) to avoid confusion: Note: This addendum is not ANSI approved and is currently going through the process to do so. The changes include: 1. Revision to Table 10. To comply with this standard, published or reported values shall be in accordance with Table 10. Table 10. Definition of Tolerances Limits Related Tolerance Equations2,3,4 Cooling or Full Load minimum: Heating 100%- Tol 1 Capacity for Full Load maximum: units with 102% 100%+ Tol1 continuous Part Load test capacity shall be unloading1 within 2% of the target part- 5 load capacity y t i c Cooling or