Creep Damage Calculation for Thermo （蠕变损伤计算热）.pdf

Strojniški vestnik - Journal of Mechanical Engineering 57(2011)5, 371-378 Paper received: 06.05.2010 DOI:10.5545/sv-jme.2010.108 Paper accepted: 07.03.2011 Creep Damage Calculation for Thermo Mechanical Fatigue Šeruga, D. – Fajdiga, M. – Nagode, M. Domen Šeruga* – Matija Fajdiga – Marko Nagode University of Ljubljana, Faculty of Mechanical Engineering, Slovenia For the needs of the creep damage prediction of thermo mechanically loaded components, software has been developed. It enables master curve determination using the time-temperature parameters and creep damage calculation using Robinson’s damage accumulation rule and simple time integration. The developed software makes it possible to calculate fatigue and creep damage, respectively. In the article the most used time-temperature parameters are introduced, a fast and user-friendly master curve determination is presented and an example of creep damage on a real set of data with a simple temperature-stress history is shown. ©2011 Journal of Mechanical Engineering. All rights reserved. Keywords: creep, damage model, parametric methods, damage accumulation, Larson-Miller, Manson-Brown, Manson-Haferd, Orr-Sherby-Dorn, master curves 0 INTRODUCTION Master curve determination at lower stress levels and lower test temperatures usually means tests Automotive components, gas and steam of very long duration, thus as a rule master curves turbines, power plants and other products that in these areas are determined by using parametric operate at high temperature are subjected to extrapolation