喷嘴安装角对管道喷雾降温影响研究.pdf

Mechanical Engineering and Technology 机械工程与技术, 2017, 6(1), 1-10 Published Online March 2017 in Hans. /journal/met /10.12677/met.2017.61001 Investigation of the Influence of Nozzle Install Angles to Spay Cooling Effect in Industrial Pipe by Numerical Simulation * Jiachen Chen , Weiliang Wu School of Energy and Power Engineering, Shanghai Jiao Tong University, Shanghai th th th Received: Feb. 25 , 2017; accepted: Mar. 14 , 2017; published: Mar. 20 , 2017 Abstract This paper investigates how different spray nozzle install angle influence the spray cooling effect inside an industrial exhaust pipe by numerical simulation software CFX. DDM (Dispersion Droplet Model) is applied to describe the motion and heat transfer progress of the atomized water droplet; the size and the distribution of the water particles used in calculation are given according to expe- riments. The particle tracks and the temperature distributions of each spray nozzle install angle with different spray mass flow are discussed basing on the simulation results. In conclusion, when the spray droplets are not completely vaporized and the nozzle install angle is 180˚, the spray cooling effect is the most satisfied. Keywords Spray Cooling, Atomization, Pipe, Install Angle of the Spray Nozzle, CFD 喷嘴安装角对管道喷雾降温影响的研究 * 陈嘉琛 ，吴伟亮 上海交通大学能源与动力工程学院，上海 收稿日期：2017年2月25 日；录用日期：2017年3月14 日；发布日期：2017年3月20 日 摘 要 为研究在废气管道内部的喷雾降温过程中不同的喷嘴安装角度对管道内高温废气的降温情况的影响，本 *第一作者。 文章引用: 陈嘉琛, 吴伟亮. 喷嘴安装角对管道喷雾降温影响的研究[J]. 机械工程与技术, 2017, 6(1): 1-10. /10.12677/met.2017.61001 陈嘉琛，吴伟亮 文采用DDM (Dispersion Droplet Model)离散液滴模型描述喷雾液滴的运动和传质传热过程，使用实验 所得的喷雾粒径数据，在CFX软件上分别对不同喷嘴