拆高压电机（High pressure machine）.docVIP

拆高压电机（High pressure machine） How to replace the motor collector ring: 1. Existing motor collector ring width of 40 mm, modified motor collector ring width will increase to 80 mm, collector ring width increase motor can improve the heat dissipation performance of collector ring, and is advantageous to the brush and brush installation of the transformation. 2. Change the electrical ring surface of the motor set to spiral groove ring surface. The electric ring surface of the old motor is planar structure. It is easy to create a small gas membrane on the surface of the brush, which is not conducive to the full contact of the carbon brush and collector ring. The new motor sets the ring surface with spiral grooves. 3. Increase the spacing of the motor collector ring. The main purpose of increasing the electric ring spacing of the motor is to prevent the sudden lifting of the unit and the short circuit between the upper and lower motor sets, reducing the probability of the electric ring surface ablation. USES and features of the collector ring introduction to generator slip ring heating phenomenon and processing opinion Brush on the collector ring is running, in the contact surface to form a layer of uniform, moderate and stable oxide film, this is a good one of the main sign of the motor running. Because of the presence of this oxide film, the contact properties of the brush and the collector ring are changed, friction reduction, wear reduction and service life are reduced. The oxide film is a composite film, which is composed of the brush type and the material composition of the collector ring. The normal thickness of the oxide film is in the range of 8-100nm, which is generally 25nm. It is observed by electron microscope that the contact surface of the brush and collector ring is made up of numerous points, and the general contact surface is only a few thousand points of the total area of the brush. The size of the contact area is determined by the factors such as the s