伊顿接头（Eaton joint）.docVIP

伊顿接头（Eaton joint） Card sleeve joint repeat installation number is limited Two, the pipe inserted into the connector body to card set close to the connector body cone surface, tighten the nut to resistance. 3, after meet resistance, vendors and the product again tight 30 degrees; WINNER products to tighten 1/4 circle. The causes for the leakage of the installation of sub - card sleeve joint A, tube is not put on two, three, nut not tighten nut tighten the four sets of deformation caused by excessive card, scratch or tube is not round pipe appearance Five, the pipe is too hard joint installation