集热器联集管（Collector of collector tube）.docVIP

集热器联集管（Collector of collector tube） Basic structure of vacuum tube The vacuum tube is like an elongated hot water bottle. 1. Inner glass tube 2. Selective absorption coating 3. Outer glass tube Inhalation film 6. Inhalant 7. Vacuum interlayer 1, inside the glass tube, and the cover glass tube vacuum interlayer, its inner wall to accommodate for thermal conductivity of the medium, outside wall attachment selective absorbing coating, and the selective absorption coating absorbed heat transfer medium to the hold. 2. Selective absorption coating: the coating is mainly composed of three parts, from the outside to the inside, respectively: anti-retro-layer, absorption layer, bottom metal layer. The anti-reflection layer mainly ACTS as the membrane and protective film. Absorption layer mainly ACTS as absorption of light energy; The base metal layer mainly ACTS as a reflection, and the heat reflected by the medium inside the inner tube is reflected back. 3. Cover glass tube: it forms a vacuum sandwich with the inner glass tube, and the external light is transmitted into the vacuum tube, and the internal protection is not damaged. 4. Card: the free end of fixed inner glass tube reduces the destructive force of relative displacement caused by the vibration between the inner and outer glass tubes; A fixed getter ensures that the suction film is properly positioned after the inhalation is baked. 5. Suction film: absorb the residual or permeable gas in the vacuum interlayer and maintain vacuum degree of vacuum interlayer. At the same time, the size and the presence of the inhalation film can also check that the vacuum tube has no vacuum. 6. Getter: hold the round boat of the getter, protect the getter, and make it not affected before the baking. 7. Vacuum interlayer: as few gas molecules as possible, reduce the heat loss caused by the convection of the vacuum tube as much as possible. Vacuum tube vacuum degree can reach the 510-4 (vacuum scale national standard 10-2) longer life