运行与维护1（Operation and maintenance 1）.docVIP

运行与维护1（Operation and maintenance 1） Environmental protection equipment operation and overhaul 9.1 basic provisions 9.1.1 before the desulfurization tower internal repair work, should be connected to the desulfurization tower of limestone slurry feed pipe, gypsum slurry discharge slurry outlet pipe, accident, accident of flue entrance/exit of the slurry into the tube, the valve or baffle door locked and unlocked, hang up the notice board. The electric valve should also cut off the motor and put a warning sign on. Stop of the desulfurization tower fan blower fan, slurry circulating pump, oxidation, flue gas heat exchanger (GGH), desulfurization tower mixer equipment such as running, and the equipment the power cut off, and put up warning signs. 9.1.2 before the desulphurization absorption tower is fired, the responsible person shall check the fire water system in the corresponding area and the water system in addition to the mist. It is strictly forbidden to do fire operation in the absorber unless the water system is not ready. During the fire, a professional guardian is set up in the operation area and the absorption tower. 9.1.3 staff, denitration facilities, desulfurization facilities into all kinds of filter before the repair work, must be corresponding boiler induced-draft fan, to the powder machine, the machine, blower, the power of the rotary air preheater, cut off, and hang up the start warning card is prohibited. 9.1.4 on boiler operation of bag filter for the maintenance of individual gas chamber, must will repair the bag filter corresponding flue gas chamber of import and export baffle door closed, and cut off the damper power, and put up warning signs. 9.1.5 into electrical precipitator, bag filter, denitration reactor overhaul, to adequate ventilation cooling, dust collector temperature should be below 40 ℃, otherwise no entry for repair work. If you must enter more than 40 ℃ of the dust collector for a short period of time at work, a specific safety mea