安萨尔多故障#（Ansaldo failure #）.doc

安萨尔多故障#（Ansaldo failure #） Ansaldo fault diagnosis 1.1 p-o (missing item) Line voltage loss protection interrupts, protection is completed by the voltage monitor hardware circuit (P15, N15 and P5). When the value of the P5 is higher than 5.25 V or less than 4.75 V, it interrupts, causing the converter to reset. Failure: terminal XM2 - U, V, W end voltage drop. Check: check the power supply voltage and synchronous voltage. Measure: reconnect. Failure: power failure. Power supply voltage overlimit, monitoring terminal p5-tp5, P15 - TP6, n15-tp7; The OV reference point is P8, terminal threshold: P5 + + + 5%, P15, N15 + + 20 %. Measures: power supply voltage value exceeds limit, replace P power board. Failure: C control board failure. Check: the power supply voltage is within the limit range. Monitoring the P5 - TP5, P15 - TP6, N15 - TP7; The OV reference point is P8, terminal threshold: P5 + + + 5%, P15, N15 + + 20 %. Measure: replace the C power board. 1.2 p-1 (external protection) External protection interrupts. Failure: terminal XM - 20 logical signal loss (+ 24V). Check: to measure the voltage of the terminal XM1-20,22, and determine its value of + 24V + 4V. Using the Logic Input of the Hardware Status function (Par. 2.2.6) to read the logical volume Input M20 Ext_P state value OFF. If the terminal voltage is zero, the logic input state ON and protection action. Measures: the terminal xm1-20 logical signal remakes the voltage of the terminal xm1-2022 is + 24V + 4V. Failure: C control board failure. Measure the voltage of the terminal xm1-20, 22, and determine its value of + 24V + 4V. Using the Logic Input of the Hardware Status function (Par. 2.2.6) to read the logical volume Input M20 Ext_P state value ON. Measure: replace C control board. 1.3 P - 2 (maximum current) The maximum protection interruption of the homeopathic current is to protect the hardware circuit that is connected to the CT load resistor (Par. 3.3). Failure: the current ring is not stable or the r