大桥施工（The bridge construction）.doc

大桥施工（The bridge construction） The bridge construction This section has a bridge 1, namely, the rock creek bridge, the central pile number K110 + 268, for the span of 30 meters of T beam structure, the bridge is 156 meters long. The upper part of the bridge is a continuous stress t-shaped beam after the first branch, and the lower part is the foundation girder, the cylinder, the frame beam, the ribbed plate and the bored pile foundation. Number of works: 60 pieces of T beams, 32 pile foundations, 12 beams and 16 columns. The drilling data shows that the soil under the riverbed is sandy soil and gravel soil, and bedrock is weakly weathered shale. Set the bento bridge on the left side of the line. Main project construction time schedule 1 January 2003 solstice 1 April 2004. (1) construction of bored cast-in-place pile The bridge has 32 bored piles, 180cm in diameter and 120cm in diameter, all of which are rock-socketed piles. The plan was completed on March 10, 2003. According to the geological condition of the bridge in this section, the drilling equipment of bored piles is used to drill the drilling equipment, and the individual shorter bored piles can be used for rotary drill (with the cone bit). The concrete is used to carry concrete, concrete conveying truck and concrete, and the concrete is filled with pipe. In order to avoid contamination of river channels, set up mud pools, mud discharge enters the mud pool, and then reuse, after the pile foundation is completed, excavate the mud and replace the river stone. Drilling pouring concrete construction procedures for buried steel liners to drilling emplacement, rushed into the (hole) to the first hole cleaning, the reinforcing cage and concrete under the catheter to the second hole cleaning, pouring underwater concrete pile to chisel in addition to the pile head, pile foundation inspection. The construction process is shown in figure 5-3 of the construction process flow chart 1. The pile location is measured and the