二级保养（Level 2 maintenance）.doc

二级保养（Level 2 maintenance） Basic operating procedures for secondary maintenance of Charley cars 1. Applicable models: Charley TJ7100, tj7130/7131, TJ7136U2000 sedan. 2. The secondary maintenance cycle of Charley series cars; 15,000 km. 3. The basic operating procedures for the secondary maintenance of Charley series cars. The basic operation schedule for the secondary maintenance of Charley sedan The serial number Maintenance projects Job content The technical requirements 1 Engine oil and oil filter 1) oil change 2) replace the oil filter 3) check the oil pressure and alarm device 1) oil specifications; The TJ376Q engine, HC - C engine is APISE, 8a-fe engine is APISH grade, EC - II or SJ grade, EC or ILSAC multi-grade oil; Lubricating oil viscosity grade (SAE standard) is selected according to ambient temperature 2) the oil filter should be injected with oil before installation. The assembly shall be reliable and well sealed 3) after preheating the engine, oil and oil leakage should not be found under the impact load 4) height requirement of liquid level: the cold car should be between L and F in oil ruler 5) total engine oil: 3.5 L 6) standard value of oil pressure: 8a-fe engine, when idle 49kPa, 3000r/min was 294 ~ 539kPa; HC - C type engine, the idle speed is 196kPa, 3000r/min is 245 ~ 490kPa 2 Air filters 1) clean air filter shell 2) change the filter element of air filter 3) check the sealing property of the thermostat and the intake system 1) the air filter is clean, effective, well sealed and reliable 2) the constant temperature inlet valve works effectively and the intake system is free of leakage 3) change the filter element of air filter for every 30,000 km 3 Engine belt and wheel 1) check the belt and wheel appearance 2) check the deflection and tension of the belt 1) the belt should be free of cracks and excessive wear and no oil on the surface, and the replacement cycle: 100,000 km of imported driving belt and 40,000 km of domestic transmission belt 2)