钢结构设计原理练习及答案14（Steel structure design principles, exercises and answers 14）.doc

下载文档 降价啦

1
0
约 12页
2017-08-04 发布于河南
举报
版权申诉
保障服务

钢结构设计原理练习及答案14（Steel structure design principles, exercises and answers 14）.doc

1、本文档共12页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

钢结构设计原理练习及答案14（Steel structure design principles, exercises and answers 14） Moni4 4 simulation questions First, fill in the blanks (each 1.5 points, a total of 15 points) 1, the shear failure form of bolt:,,, and . Answer The answer cut bolt hole wall, crushing, steel plate is broken, end plate, punching shear bending failure of bolt. 2, bearing type high strength bolt connection only used to bear the load and load of structure. Answer The static and dynamic indirect answer 3, in the design of steel structures, steel strength design value is the standard value of material strength and resistance factor. Answer Answer by 4, the minimum fillet weld leg size HT, min=1.5, t. Answer The answer is connected with the maximum thickness of plate 5, member slenderness ratio refers to the ratio of (represented by the symbol). Answer Answer Two, choice (each of 1 points, a total of 10 points) 1, the design strength of steel is determined according to the. The proportional limit (A) The elastic limit (B) The yield point (C) (D) the ultimate strength. Answer: C 2, steel after strain hardening (strain hardening) after. (A) strength (B) the increase in plasticity (C) to improve the performance of cold (D) to improve the weldability of the answer Answer: A In 3, the roof truss rod force is small, usually in the section. (A) allowable slenderness ratio selection (B) construction decision (C) deformation decision (D) decided to answer the local stability Answer: A The base plate thickness, 4 axial compression column is at bottom. (A) to determine the bending work (B) to determine the compression work (C) to determine the shear (D) bending and compression to determine the answer Answer: A 5, when the material is Q235-BF steel and Q345-BF steel, connected with manual welding, welding should be adopted. (A) E43 steel (B) E50 steel (C) low alloy steel E50 (D) low alloy steel E55 answer Answer: A 6, the axial compression of lattice structures in the calculation of the overall stability aro