烤漆(喷塑)和颜色的检验标准方法（Standard Test Method for paint (spray) and color）.doc

下载文档 降价啦

26
0
约1.09万字
约 16页
2017-08-04 发布于河南
举报
版权申诉
保障服务

烤漆(喷塑)和颜色的检验标准方法（Standard Test Method for paint (spray) and color）.doc

1、本文档共16页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

烤漆(喷塑)和颜色的检验标准方法（Standard Test Method for paint (spray) and color） The following is the processing, paint (spray) and color standard methods for the examination, please enlighten 1. parts This section provides a test and assembly processing unified standard. These guidelines and PSCS, will be the companys suppliers and related staff to use to check first, purchasing, incoming inspection, assembly and final audit. The ultimate goal is for the best parts manufacturing and assembly line. 1.1 check standard 1.1.1 inspector qualification The inspector must have one or more of the following One year working experience of quality inspector?. ? after the system of education and training, at least 40H. Special training and recognition level? Work through the verification, and immediately engaged in inspection work. ? that is directly management consultation and decision-making problems in appearance. 1.1.2 inspection process All parts should be clean and free of grease, oil and other substances. The transport of materials and can be caused by dust blowing air can be received. 1.1.2.1 test brightness 80-120? (FOOTCANDLE lighting unit refers to the illuminance per FT in distance) From the perspective of 1.1.2.2 test The inspector to make the workpiece surface into a 30 degree angle, and left and right along the vertical axis of the rotating 30 degrees. Parts with multiple sides, each side must be considered as a separate plane to test. 1.1.2.3 distance test 1: 460 mm 2: 460 mm 3: 610 mm The hole and other parts is not limited to above test distance. The time required for 1.1.2.4 1 2: The maximum observation time of each 10cm2 with 4 seconds, each face maximum of 20 seconds (usually every 5 seconds a face), time due to component complexity and 3: The maximum observation time per 10cm2 in 2 seconds. (usually every 10 seconds a surface) When a surface is not defined in the drawing or order, according to the general requirements. When there are differences, the main figure. 1.1.3