必修一化学（Required chemistry）.doc

必修一化学（Required chemistry） High chemistry compulsory 1 key and difficult problem sets (multiple-choice question) 1, the sulfuric acid density of 1.32g/mL drops into the BaCl2 solution, until the precipitation completely. The mass of the solution being known is equal to the mass of the original BaCl2 solution, and the concentration of the H2SO4 solution is (BD) A.21.9% B.42.1% C.13.5mol/L D.5.67mol/L 2, 4.34gNa, Na2O, and a mixture of sufficient Na2O2 water reaction, 672mL gas mixture under normal conditions, the mixed gas through the discharge, exactly the reaction, their molar ratio (D) A., 1:1:1, B., 1:1:2, C.1:2:1, D.4:3:2 In 3, a, B, C and D four beaker were put into 0.1mol sodium, sodium oxide, sodium hydroxide and sodium hydroxide, then add 100mL water stirring, the solid is completely dissolved, the mass fraction of the size of a, B, C and D for (B) A. a, B, C, Ding, B. Ding, A, B = C, C. A. = Ding, B = C, D. Ding, A, B, C 4, the existing 100mL3mol/L solution of NaOH and AlCl3 solution of 100mL1mol/L. NaOH solution was added to AlCl3 solution several times; secondly, AlCl3 solution was added to NaOH solution several times. The phenomenon of two operations and the quality of precipitation are compared (C) A. phenomenon is same, precipitation quality is unequal, B. phenomenon is same, precipitation quality is equal The C. phenomenon is different, the precipitation quality is equal, the D. phenomenon is different, the precipitation quality is unequal 5, to a certain amount of Fe, FeO, Fe2O3 mixture, adding 100mL concentration of 1.00mol/L hydrochloric acid, just to make the mixture completely dissolved, there is gas release, the solution after the addition of KSCN solution, no blood red appear. If sufficient amounts of CO are used to reduce the same mass at high temperature, the quality of the iron can be obtained (C) A.11.2g B.5.6g C.2.8g D.1.4g 6, a certain amount of sodium is put into the 50gFeCl3 solution. After the reaction is finished, the yellow solution