600 Series Disk and Drum Lathe Operators Manual（600系列盘式和鼓车床操作手册）.pdf

600 Series Disk and Drum Lathe Operators Manual FORM 3804-11 CHECK LIST 1. Standard equipment is shown on page 3. 2. Optional accessories are available from your John Bean Dealer. You may also order by contacting John Bean Company, Exchange Ave., Conway, AR.72032 or by calling 1 - (800) 362-8326 3. Assemble deluxe bench if ordered. The lathe can be mounted on either when removed from the carton. SAFETY INSTRUCTIONS Repair or replace damaged or worn 5. DON’T FORCE LATHE. It will do Warning! cords immediately. the job better and safer at the rate for For Your Own Safety, Read Instruc- This tool is intended for use on a which it was designed. tion Manual Before Operating Lathe circuit that has an outlet that looks like the one illustrated in Sketch (A) be- 6. USE RIGHT TOOL. Don’t force 1. Lathes are supplied with a three- low. The tool has a grounding plug lathe or attachment for a job for which wire cord to provide grounding if your that looks like the plug illustrated in it was not designed. electrical system is properly installed Sketch (A) above. A temporary by a qualified electrician and in com- 7. WEAR PROPER APPAREL. Do pliance with the national, regional and not wear loose clothing, gloves, neck- local electrical codes. tie, rings, bracelets, or other jewelry 2. Improper grounding can cause that might get caught in moving parts. electrical shock. In the event of a Nonslip fo