A LLIED C ONCRETE（增加C混凝土）.pdf

ALLIED ALLIED CONCRETE CO. 1000 HARRIS STREET ¥ P.O. BOX 1647 CHARLOTTESVILLE, VIRGINIA 22902 CONCRETE BLOCK SIZES AND SHAPES TABLE OF CONTENTS Specifications For CMU3 Blocks 2î, 3î and 4î4 Blocks 6î5 Blocks 8î6 Blocks 10î and Miscellaneous7 Blocks 12î and 14î8 Blocks Split Face 9 Blocks Split Face w/ Corner Details10 Embossed Brick Face11 Estimating Guides and Volumes12 Specifications For Concrete Masonary Units Concrete Masonary Units A. General: Comply with the requirements Indicated Below. 1. Size: Provided concrete masonary units complying with requirements indicated below for size are manufactured to specified face dimensions within tolerances specified in applicable referenced ASTM specification. A. Manufacture concrete masonary units specified dimensions of 3/8 inch less than nominal widths by nominal heights by nominal lenghts. 2. Provide special shapes where indicated and as follows: A. For Lintels, corners, jambs, sash, control joints, headers, bonding and other special conditions B. Square-edged units for outside corners except where bullnose units are indicated. B. Hollow and solid load-bearing concrete masonary units: ASTM C 90 and as Follows: A. Type II B. Weight Classifications: lightweight (maximum density of less than 105 PCF) and a maximum linear drying shrinkage of 0.065% when tested in accordance with ASTM C 426. Fabricate using lightweight aggregate that strictly conforms to ASTM C 331. Normal weight aggregates, when used in blending with lightweight aggregates to achieve a smooth, tight texture, shall conform to ASTM C 33. C. Unit compressive