Basic Snare Drum Technique Pearl Drums（基本的小军鼓技术珍珠鼓）.pdf

Basic Snare Drum Technique By Thom Hannum There are a number of effective methods for learning basic snare drum technique. So be open to suggestions and seek a teacher to help guide you through the fundamentals. Below are some guidelines to get you started. Have fun! Stand Assembly and Instrument Position 1. Spread the base of the stand far enough to create a stable platform. 2. Insert the top into the base of the stand. 3. Place the drum into the basket while avoiding contact with the snare strainer. 4. The drum should be at about waist level and slightly angled for your comfort. 5. Tighten all stand wing nuts. Step 1 Step 2 Step 3 Step 4 Step 5 Tuning and Stick Selection Now it’s time to tune the drum for the best possible sound. I recommend following the steps outlined in Tom Freer’s Pearl article, Basic Snare Drum Tuning , which can be found at Pearl’s website (). Have your teacher help select snare sticks that work for you. Something equivalent to a 2B or a 5B usually works fine. The balance point is 1/3 of the way up from the butt end of the stick. Grip the stick near this point for the best response and bounce. Grip Guidelines and Posture Learning to hold the sticks properly is essential for improving technique. Use the photos as a guide and make sure to memorize the feel of the following guidelines: # 1 Fulcrum (thumb and first two fingers), #2 Finger contact (comfortably wrap all fingers around the stick; not too tight), #3 Bead placement (as close together as possible for an even sound) and then striking area (center of the drum head), #4 Wrist motion (down position and up position). #1 Fulcrum #2 Finger Contact #3 Bead Placement #4 Down Position #4 Up Position Stand with your legs slightly separated and your arms