Build your own paddle steamer Forgotten （构建自己的桨轮船,遗忘）.pdf

Forgotten Futures – The Scientific Romance Role Playing Game Build Your Own Paddle Steamer ~ Marcus L Rowland wheel covers aft deck engine house forward deck capstan This file contains everything needed to make a model of the ship shown above from the deck upwards, and a flat plan of the areas below decks. For the purposes of running an adventure the flat deck plans (pages 3-5 and possibly 12-14) may be all that’s needed; just tell players that the aft deck is at a higher level, and that the wheel house is on top of the engine house. Print them onto thin card, optionally laminate them, cut out the pieces and tape them end to end; once made they’re ready for use in a few seconds. Stick the boat on the stern and the capstan onto the deck forward of the hold. For a more challenging project print the whole file and assemble a complete model. This isn’t particularly difficult, but you will need the following: • Sharp scissors or a scalpel and cutting mat • Adhesive tape and double sided tape • A drinking straw or thin wooden dowel about 6-8” long • A toothpick or similar wooden rod such as part of a skewer • Thread • Thick wire to make boat davits etc. • Glue The deck rails look best if they can be printed onto clear acetate. ~ http://www.forgottenfutures.co.uk This file has been supplied as a FREE download; if you are asked to pay for it please let me know! 1. Assemble the flat model (pages 3-5) and if possible glue it to a thicker base such as a piece of thick card. 2. Glue the capstan to card and cut it out – find something to raise it above the deck, e.g. a short length of dowel rod, and glue it to the deck over the small circle forward of the hatches. 3. Cut out the small bo