BUILDING A ELMER MACCAFERRI UITAR （建立一个埃尔默MACCAFERRI UITAR ）.pdf

BUILDING A SELMER MACCAFERRI GUITAR A step-by-step guide to building a laminated body Selmer-Maccaferri guitar Michael Collins The Heel The heel should now be prepared to be glued to the neck shaft. Using the neck template, transfer the curve of the heel to the side of your block. The block must include the extra depth for the dovetail. Rough-cut the curve of the block on the band saw to reduce some of the waste you must carve later. 13.23: The neck shaft side template is used The sides of the oval hole block should be tapered so to layout the rough shape of the heel 1 3 block. Use the full size diagram sup- the top is 2 / in•57.1mm and the base is 1 / in•44.4mm. 4 4 plied when you make your side tem- 7 The sides of the D-hole block should be 2 /16 •61.9mm plate. 1 at the top and 2 /8 •53.9mm at the base. These tapers must reference the centerline of the block to keep everything in order. Once the heel has been correctly roughed out, glue it into position on the neck shaft. Use two clamps and prevent the block from slipping out of position as you set the clamps. Allow the entire glue-up to dry for a minimum of 13.24: one hour. The heel taper is drawn so it is slightly oversize on the block and cut on the ba